Installation Guide 08+ Dodge Challenger Harness Bar CPA5009HB




CPA5009HB - 2008+ Dodge Challenger Harness Bar

Installation Guide



Download CPA5009HB - 2008+ Dodge Challenger Harness Bar Installation Guide PDF Version
Download CPA5009HB - 2008+ Dodge Challenger Harness Bar Installation Guide PDF Version

Installation

1) Tilt seats forward toward front of car.

2) Remove Seat Belt Cover
a. Remove plastic trim pieces that cover the seat belt opening
b. Plastic pieces are snap on, a small screwdriver may be required to unlatch them

3) Unbolt Driver’s Side Seat Belt Anchor
a. At base of B-Pillar locate seat belt anchor
b. Remove bolt holding Rear of seat belt Rail
c. remove spacer and retaining clip from rear bolt
d. loosen front bolt slightly

4) Unbolt Passenger’s Side Seat Belt Anchor
a. At base of B-Pillar locate seat belt anchor
b. Remove bolt holding Rear of seat belt Rail
c. remove spacer and retaining clip from rear bolt
d. loosen front bolt slightly

5) Remove Front Bolt from behind cover removed in step 2

6) Install Main Harness Bar
a. Position main harness bar ends into the B-Pillar shoulder belt opening
b. Install supplied bolt through holes with a washer and spacer on each. Do not tighten completely
c. Repeat for opposite side; again do not fully tighten fasteners.

7) Prepare Tension Rods:
a. Install a rod end with jam nut into each Upright Tension rod

8) Install upright Tension Rods
a. Install bottom of tension rod first.
b. Position rod so that the bottom rod end is flat against the inside of the floor seat belt rail where spacer was removed in step 3 and 4
c. Install supplied bolt through holes with a washer on each. Do not tighten completely
d. Repeat for opposite side.

9) Install Tension Bar Rod Ends into Main Harness Bar
a. Determine final position of Main Harness Bar
b. Bar should be level and evenly spaced in the car.
c. Move tension rod into position to bolt into the lower bracket of the Main Harness Bar.
d. Adjust Rod End to desired height in order to match holes in Main Harness Bar.
e. Install supplied bolt through holes with a washer on each side and fix with nylock nut. Do not tighten completely
f. Repeat for opposite side

The following instructions only apply to kits in which you will be cutting your own seat belt covers.

10) Cut B-Pillar Panel
a. measure and determine amount of material to be removed from b-pillar cover to allow spacer to pass through.
b. carefully cut cover using a dremel or other small detailed cutting tool.
c. Repeat for opposite side.

11) Install Cut Seat Belt Covers
a. Now that the Main Harness Bar has been set in place tighten the bolts on the B-Pillar Brackets that were installed in step 5.
b. Re-Install the cut seat belt cover under the installed Harness Bar.

12) Tighten all Bolts
a. Do a bolt check
b. Ensure that Main Harness Bar is in final desired position and tighten all bolts to the B-Pillar Brackets, Upright tension Rods, Floor Brackets, and tighten the jam nuts on the Rod Ends.
c. Install Seat Trim removed in Step 2.

13) Install Seat Belts
a. Install you seat belts as desired onto Harness Bar.