Installation Guide 05+ Ford Mustang Harness Bar CPA5001HB




CPA5001HB - 2005+ Ford Mustang Harness Bar

Installation Guide



Download CPA5001HB - 2005+ Ford Mustang Harness Bar Installation Instruction PDF Version
Download CPA5001HB - 2005+ Ford Mustang Harness Bar Installation Instruction PDF Version

2005-2014 Ford Mustang
Part # CPA5001HB


Disclaimer

  • Motorsports can be extremely dangerous. No warranty or representation is made as to this Harness Bar ability to protect the user from any injury or death, the user assumes that risk.

Installation

Note: You will need a *50 Torx bit for the installation

  • - Unsnap the upper stock plastic shoulder belt cover and remove the bolt. You will need to do this on both sides of the both vehicle.
  • - Remove the stock retaining washer and spacer from the factory belt, and place the spacer back in the pillar.
  • - Assemble the stock belt and harness bar. Install the harness bar into your vehicle. There might be slight tolerance variations from vehicle to vehicle. Because of this you may need to adjust the ends slightly for proper fitment. At this time you will not fully tighten the bolts.
  • - Loosen and remove the lower Torx head bolt. Remove the retaining washer and spacer from the bolt. You will need to do this on both sides of the vehicle.
  • - Using the supplied bracket, support rods and hardware, assemble the brackets.
  • - For the passenger side you will need to retain the stock spacer. You will then reinstall the stock Torx head bolt into the stock mounting position.

  • For more info please check our YouTube Installation video channel or simply call us at 909-542-8868.